Pulling Classes

Following NR/CTPA but with some changes. All curent classes are for carpet pulling only.

  Digger:    Motor:  Maximum of one Stock motor.  Battery:  6 cell "C" size maximum, ½ sub "C" minimum  Chassis:  Must be in stock configuration. Parts may be missing. Holes may  be drilled for mounts only. All unused non-factory holes must be filled  with epoxy so as to maintain factory weight. Aluminum hubs are allowed.  Tires:  Rear tires are to be a maximum 3 ½" diameter, and a maximum of  2" wide. Front tires are to be a maximum of 2 ½", the stock tire size.  The minimum front tire size is 1 3/8"  Weight:  Maximum weight is 4 lbs.  Dimensions:  Maximum vehicle width is 9 inches.  Wheelbase:  Wheel base is 8 inches and stock for this vehicle.  Hitch:  Hitch is the wheelie bar. Rollers may be added for horizontal adjustment. The aluminum bar may be replaced with a plastic bar.  Body:  Factory replacement body or any 1/12 scale body. The body is to be the furthest item forward.  Other:  No gearing limit.   

  Garden Tractor:  
    Motor:  Maximum of one Modified motor with a maximum MSRP of  $125.00. No motors larger than a 550 can, Astroflight Pullmaster I, or  an equivalent.  Battery:  6 cell "C" size maximum.  Chassis:  May be factory production or scratch built.  Tires:  Maximum rear tire diameter is 4 inches. Maximum rear  tire width is 2 ¾ inches. Minimum front tire diameter of 1 inch. Rear  tires must have "V" bar tread pattern. TLT tires are acceptable.  Weight:  4 lbs maximum.  Dimensions:  Maximum vehicle length of 12 inches. Length is measured from the rearmost part of the hitch to the furthest point forward.  Wheelbase:  Maximum of 9 inches.  Hitch:  Maximum hitch height of 2 inches. Body: Will have the appearance of a scale stock or modified garden tractor.  Wheelie Bar:  Vehicle may have wheelie bars. The wheelie bars may not  extend more than 2 inches past the rearmost portion of the hitch. Wheels  may be replaced with skid pads.       5lb 2WD Truck:  
    Motor:  Maximum of one Econo Modified motor with a maximum MSRP of $60.00.  Battery:  7 cells "C" size maximum.  Chassis:  May be scratch built or a combination of kit components.  May be built with any of the following: Steel, aluminum, fiberglass, or  plastic.  Tires:  Rear tires are to be Tamiya "Wild Willies, Lunchbox, or  Midnight Pumpkin" type tires only, tires can NOT be cut or sharpened in  any way. Front tires are to be a minimum of 2 ¼" in diameter.  Weight:  Maximum vehicle weight is 5 lbs.  Dimensions:  Maximum length is 19 inches. Maximum width is 9 inches.  The furthest point forward from the center-line of rear axle shall be no  further than 15 inches.  Wheelbase:  Maximum wheelbase of 11 ½ inches.  Hitch:  2 inch maximum hitch height.  Body:  Must use a truck, van or car body only. All components must be under the body. Front tires must be in wheel opening.        7lb 2WD Truck:  
    Motor:  Maximum of one Econo Modified motor with a maximum MSRP of $60.00.  Battery:  7 cells "C" size maximum.  Chassis:  May be scratch built or a combination of kit components.  May be built with any of the following: Steel, aluminum, fiberglass, or  plastic.  Tires:  Rear tires are to be Tamiya "Wild Willies, Lunchbox, or  Midnight Pumpkin" type tires only. Front tires are to be a minimum of 2  ¼" in diameter.  Traxxas Stamped tire are acceptable.  Weight:  Maximum vehicle weight is 7 lbs.  Dimensions:  Maximum length is 19 inches. Maximum width is 9 inches.  The furthest point forward from the center-line of rear axle shall be no  further than 15 inches.  Wheelbase:  Maximum wheelbase of 11 ½ inches.  Hitch:  2 inch maximum hitch height.  Body:  Must use a truck, van or car body only. All components must be under the body. Front tires must be in wheel opening.  
     Pro Stock Tractor:   Motor:  Maximum of one Econo Modified motor with a maximum MSRP of $60.00.  Battery:  7 cells "C" size maximum. Battery shall be placed in a fashion  so that it can not be seen from either side, front, rear or top of the  tractor.  Chassis:  Chassis may be scratch built or combination of kit components.  Tires:  Rear tires are to be a maximum of 6 ½ inches. The Maximum tread  width is 4 ½ inches. Must be agricultural single "V" type bar tire.  Stock E-Maxx tires are allowed. Tires are not allowed to be cut.  Weight:  Maximum tractor weight is 10 lbs. Any visible weight must be  scale suitcase weights. These weights are allowed to stick out past the  body within the maximum tractor width.  Dimensions:  Maximum over all length is 19 inches. Maximum tractor width is  14 inches. Maximum tractor length is 18 ¾ inches. The wheelie bars may  be ¼ inch past the rearmost part of the tractor. The furthest point  forward shall be no further than 15 ½ inches from the center of rear  axle.  Wheelbase:  Maximum wheelbase is 11 ½ inches.  Hitch:  Maximum hitch height of 2 inches.  Body:  Must be a 1/10 scale Pro-stock or Super-stock Farm tractor body.  Any make, model and year are allowed. Tractor may be built to resemble a  four wheel drive tractor but must remain two wheel drive. Tractor must  have fenders of some type. It is suggested, not required that the  tractor should smoke, have a driver and a transmission blanket for  realism.   

  Super Stock Tractor:  Motor:  Maximum of one Modified motor with a maximum MSRP of $120.00.  Brushless acceptable.
 Battery:  7 cells "C" size maximum. Battery shall be placed in a fashion  so that it can not be seen from either side, front, rear or top of the  tractor.  Chassis:  Chassis may be scratch built or combination of kit components.  Tires:  Rear tires are to be a maximum of 6 ½ inches. The Maximum tread  width is 4 ½ inches. Must be agricultural single "V" type bar tire.  Stock E-Maxx tires are allowed. Tires are allowed to be cut.  RC4WD  Traxtor XL Pulling tires acceptable.
 Weight:  Maximum tractor weight is 10 lbs. Any visible weight must be  scale suitcase weights. These weights are allowed to stick out past the  body within the maximum tractor width.  Dimensions:  Maximum over all length is 19 inches. Maximum tractor width is  14 inches. Maximum tractor length is 18 ¾ inches. The wheelie bars may  be ¼ inch past the rearmost part of the tractor. The furthest point  forward shall be no further than 15 ½ inches from the center of rear  axle.  Wheelbase:  Maximum wheelbase is 11 ½ inches.  Hitch:  Maximum hitch height of 2 inches.  Body:  Must be a 1/10 scale Pro-stock or Super-stock Farm tractor body.  Any make, model and year are allowed. Tractor may be built to resemble a  four wheel drive tractor but must remain two wheel drive. Tractor must  have fenders of some type. It is suggested, not required that the  tractor should smoke, have a driver and a transmission blanket for  realism.   

  Bar Tire Sportsman:       Motor:  Maximum of one Econo Modified motor with a maximum MSRP of $60.00.  Battery:  7 cells "C" size maximum.  Chassis:  May be scratch built or a combination of kit components.  May be built with any of the following; Steel, aluminum, fiberglass, or  plastic.

 

Pro Modified Diesel: Motor:  Econo mod motor 1 $60.00 retail  Battery:  7 cell sub c may not be located any farther forward on chassis than stock location.  Chassis:  A Hi-Lift, and SCX10 chassis must be used. Axles may be  locked. Transmission may be modified or after market, but must be in  stock location for the Chassis. Rear suspension may be locked. Front  suspension to be left factory with the exception of after market shocks.  Wheelbase can be no more then 14.5" center to center ( when lengthening  the wheel base, body must match up with wheel wells, either a exstended  cab or quad cab body ).  Duals can not be wider then 11.25 inches.   Weight:  10 lbs and all non scale appearing weights must be out  of site from normal viewing. Weight boxes permitted. Weights may not  exceed 5 inches from center of front axle forward.  Hitch:  Is to be 2-inch max. must meet all other NR/CTPA hitch rules.  Tires:  Any 1.9 tire allowed, dual wheels permitted ( if running  dual's, body must have dualy fenders ).  All tires must be the size and  brand on front and rear axle.  Any 1.9 wheel may be used.  Tires may be  cut.   Body:  Shall represent a street licensed Diesel pick-up as you  would see pulling at a local fair. If wheel base has been lengthened,  body must be a extended cab or crew cab. Shall have at least one exhaust  stack facing upward either in the bed or on the hood. This will be left  up to the participant.         Insane: Motor:  No motor restrictions. May only use Electric power plant. Must be safe.  Chassis:  Chassis may be scratch built or combination of kit components.  Weight:  Maximum vehicle weight is 15 lbs.  Dimensions:  Maximum vehicle length is 18 inches. Maximum vehicle width is 12 inches.  Hitch:  Maximum hitch height of 2 inches. Body: Must resemble  some kind of full scale pulling vehicle. For any unusual vehicles it is  recommended that participant have a photo of the full scale puller.  Safety:  Must have shielding to contain flying parts. The body  may be considered to be the shielding. Must have a hitching point for a  safety tether or kill switch. The hitch point must be just above the  pulling hitch if using a safety tether. If the vehicle is Nitro or  Gasoline operated, the vehicle will be hooked to the sled, an anchor or  set on a cradle before starting      :